N184DC is a 2018 Vans Aircraft RV-8A. It is a fixed-wing single-engine aircraft with 2 seats, powered by a Superior XP-IO360B1DA3 rated at 180 horsepower. The registration is active, with the registrant based in Newalla, OK. Its experimental airworthiness certificate was issued in Sep 2018. It has been registered to its current owner since May 2016. This page also carries 1 NTSB event.
- 8 years old
- 1 of 297 Vans Aircraft RV-8A
2018
2016
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N184DC's record changes.
On August 14, 2024, about 2021 central daylight time, a Vans RV-8A airplane, N184DC, sustained substantial damage when it was involved in an accident near Guthrie, Oklahoma. The pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
According to the pilot, about 40 ft agl during the initial climb from the grass airstrip, engine cylinder Nos. 2 and 3 lost power. About 10 seconds later, engine cylinder Nos. 1 and 4 lost power. The pilot was unable to maintain altitude. He switched fuel tanks in an attempt to regain engine power but noted no change in the engine performance. The airplane impacted trees beyond the departure end of the runway. The airplane sustained substantial damage to both wings, fuselage, and empennage.
Postaccident examination of the engine revealed no compression was noted on the No. 2 cylinder. The air filter was removed from the fiberglass air snorkel/box, and one of the four fabricated retaining brackets was separated and missing (see Figure 1). Elongation was noted on the fiberglass where the rivets secured the fabricated retaining bracket.
Figure 1. Air filter retaining brackets; one bracket separated and missing.
The No. 2 cylinder intake tube was removed, and a foreign metal piece, consistent with the separated retaining bracket, was observed within the cylinder. The bracket was jammed in the cylinder and under the intake valve seat. The intake valve and retaining bracket were removed from the cylinder and photo documented (see Figures 2 and 3).
Figure 2. No 2. cylinder intake and separated retaining bracket.
Figure 3. Separated air filter retaining bracket located in the No. 2 cylinder intake.
No photos yet. Sign in to add the first one.