N210WP is a 2014 Zenith Aircraft CH750. It is a fixed-wing single-engine aircraft with 2 seats, powered by a Viking 110 rated at 110 horsepower. The registration is active, with the registrant based in Mc Cune, KS. Its experimental airworthiness certificate was issued in Jul 2019. It has been registered to its current owner since Oct 2018. This page also carries 1 NTSB event.
- 12 years old
- 1 of 27 Zenith Aircraft CH750
2019
2018
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N210WP's record changes.
On September 20, 2020, about 1145 central daylight time, an experimental, amateur-built CH 750 airplane, N210WP, was substantially damaged when it was involved in an accident near Montrose, Missouri. The pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
According to the pilot, while enroute to his destination airport, the engine momentarily lost power. He immediately selected the alternate fuel pump and engine control unit (ECU), and the engine regained power. About 5 minutes later, the engine lost total power, and the pilot attempted to restart the engine. The engine restart was unsuccessful, and the pilot initiated a forced landing to a field. During the forced landing, the airplane's landing gear contacted the high vegetation, and the nose impacted terrain. The airplane nosed over and came to rest inverted. The airplane sustained substantial damage to the left wing leading edge and the rudder.
Postaccident examination of the airplane revealed that the main fuse block, located behind and under the instrument panel, was discolored and exhibited internal thermal damage. An automotive blade-type fuse, that connected to both primary and secondary fuel pumps and primary and backup ECUs, displayed arcing signatures, and had failed. According to the engine manufacturer, who responded to the accident site, the primary and secondary ECUs should have been wired directly to the main bus and should not have contained a fuse. After bypassing the failed electrical system, an engine test run was performed. The engine started and operated normally with no mechanical issues noted.
The accident airplane had not been modified in accordance with an engine manufacturer service bulletin that recommended an ECU wiring upgrade. The upgrade removes the ECU select switch to operate on a single computer only.
No photos yet. Sign in to add the first one.