N28067 is a 1979 Bellanca 17-30A. It is a fixed-wing single-engine aircraft with 4 seats, powered by a Cont Motor IO 520 series rated at 285 horsepower. The registration is active, with the registrant based in Minneapolis, MN. Its standard airworthiness certificate was issued in Sep 1979. It has been registered to its current owner since Jan 1998. This page also carries 1 NTSB event.
- 47 years old
- 1 of 427 Bellanca 17-30A
1998
1979
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N28067's record changes.
On December 2, 2020, about 2115 central standard time, a Bellanca 17-30A, N28067, was substantially damaged when it was involved in an accident near Arden Hills, Minnesota. The pilot and passenger and an occupant of the motor vehicle were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
The pilot stated the accident flight was a night sightseeing flight around the city. About 10 minutes after takeoff, he heard a loud “bang,” and the engine began to vibrate. Shortly thereafter, the engine lost power completely. The pilot made a gear-down forced landing on an interstate highway. During the landing roll, the airplane struck a vehicle and highway divider.
Postaccident examination revealed both wings were bent. In addition, a hole was observed on the top of the engine crankcase, and the cylinder Nos. 5 and 6 connecting rods were missing.
An engine examination revealed a large amount of metal debris in the oil pan. The oil filter also contained metal chips and filings. Recovered fragments included portions of the two connecting rods, the corresponding rod caps, and the associated rod bolts and nuts. Two rod cap nuts were found loose in the oil pan without any portion of the associated rod cap bolts. In addition, one rod bolt retained by the connecting rod was recovered but did not have a nut on the threaded end. The other rod bolts exhibited mechanical damage, separated threaded portions, or were not located.
Airplane maintenance records indicated that the engine had accumulated 1,296 hours since overhaul which was completed about 16 years prior to the accident. A maintenance entry dated September 13, 2012, indicated that the Nos. 1, 4 and 6 cylinders were removed and reinstalled due to low compression. It is not known if the connecting rods were removed at this time. According to the most recent annual inspection, completed on October 7, 2020, the engine had accumulated 396 hours since the removal and replacement of cylinder Nos. 1, 4, and 6. The No. 6 cylinder was replaced about 8 years and 396 hours time-in-service prior to the accident.
No photos yet. Sign in to add the first one.