N369PA is a 1996 Bell 407. It is a rotorcraft with 7 seats, powered by a Rolls-Royc 250-C47B rated at 650 horsepower. The registration is active, with the registrant based in Broussard, LA. Its standard airworthiness certificate was issued in Jun 2023. It has been registered to its current owner since Sep 2023. This page also carries 1 NTSB event.
- 30 years old
- 1 of 389 Bell 407
2023
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N369PA's record changes.
The helicopter flight instructor reported that, during a training flight, he briefed the student pilot on the procedures required to land with a simulated stuck left pedal. The student began a descent to enter a shallower-than-normal glide path to the runway surface, and he completed his final checks for the maneuver and continued the approach.
Upon contacting the runway, the helicopter veered to the left, and the instructor elected to abort the landing. As the helicopter lifted off, it began to yaw to the left at a rapid rate, while drifting to the left of the runway. Recognizing the helicopter was in a spin, they attempted to correct by leveling the helicopter "long enough for the aircraft to regain tail-rotor authority." The helicopter's left skid impacted the mud on the left side of the runway and the helicopter rolled onto its left side.
The Federal Aviation Administration's Helicopter Flying Handbook, FAA-H-8083-21A, provides information and guidance in a section titled "Landing – Stuck Neutral or Right Pedal" which stated in part:
The landing profile for a stuck neutral or a stuck right pedal is a low-power approach terminating with a running or roll-on landing. The approach profile can best be described as a shallow to normal approach angle to arrive approximately 2–3 feet landing gear height above the intended landing area with a minimum airspeed for directional control.
During the approach the flight instructor directed the student pilot to "utilize throttle manipulation to control the yaw caused by a fixed input on the anti-torque system."
The manufactures service letter, SL 19-002 A, states, "During in-flight tail rotor control failure simulation, pilots should never use the twist grip to control yaw."
The helicopter sustained substantial damage to the main rotor, fuselage and tail-boom.
The flight instructor reported that there were no preaccident mechanical failures or malfunctions with the helicopter that would have precluded normal operation.
The automated weather observation station located on the airport reported that, about the time of the accident, the wind was variable at 4 knots.
No photos yet. Sign in to add the first one.
More from Gm Leasing
FAA record- N1170 · Bell Helicopter Textron Canada 407
- N127AP · Bell 206B
- N141AP · Bell 407
- N1612 · Bell 407
- N161SF · Bell 206-L4
- N1751 · Bell 206B
and 29 more registered to the same entity in LA.