N41852Raymond Z Brown CONDOR · 2012

On February 1, 2016, about 1435 central standard time, an amateur-built Condor gyroplane, N41852, impacted terrain near Centralia, Illinois. The sport pilot was fatally injured and the gyroplane was substantially damaged. The gyroplane was registered to and operated by a private individual under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed for the flight, which operated without a flight plan. The local flight originated from the Centralia Municipal Airport (KENL), Centralia, Illinois at an unknown time.

According to information obtained by the responding Federal Aviation Administration (FAA) inspectors, an instructor pilot rated eyewitness watched the gyroplane as it departed runway 36. Upon reaching 300 ft above ground level, the gyroplane began a right turn. During the climb, the gyroplane rotor blades began to slow down. Another witness reported that the engine lost power. The gyroplane made a "tight" left turn towards the airport. It then rolled wings level and began descending in a flat attitude. Prior to impact, the gyroplane pitched up abruptly and impact the ground. The accident occurred about 1 mile from the airport.

The pilot, age 63, held a sport pilot certificate issued on August 24, 2012. His log book was not located during the course of the investigation, and his flight experience could not be determined. He used a valid driver's license to exercise sport pilot privileges rather than possessing an FAA medical certificate.

The single-engine, two tandem seat gryoplane was manufactured in 2012 by the accident pilot. It was powered by a Subaru EJ22 engine driving a four-bladed composite Warp Drive propeller and equipped with Dragon Wings rotor blades. It was issued a Special Airworthiness Certificate as an experimental amateur build on December 22, 2012. The builder listed the gyroplane as a Condor and it followed the design of a Rotor Flight Dynamics Twin Dominator.

The gyroplane restraint system consisted of a single lap belt.

At 1435, an automated weather reporting station located at ENL reported a wind from 040 at 5 knots, visibility 10 miles, a clear sky, temperature 54° F, dew point 32° F, and a barometric pressure of 29.99 inches of mercury.

The single-engine, two tandem seat gryoplane was manufactured in 2012 by the accident pilot. It was powered by a Subaru EJ22 engine driving a four-bladed composite Warp Drive propeller and equipped with Dragon Wings rotor blades. It was issued a Special Airworthiness Certificate as an experimental amateur build on December 22, 2012. The builder listed the gyroplane as a Condor and it followed the design of a Rotor Flight Dynamics Twin Dominator.

The gyroplane restraint system consisted of a single lap belt.

The gyroplane came in rest on its left side in an open field. All major components were located at the accident site. There was an impact crater located next to where the wreckage had come to rest. The fuselage was slightly twisted and the main rotor blades were bent, but remained attached to the rotor mast.

As of the writing of this report, an autopsy did not reveal any medical concerns with the pilot. The manner of death resides with the Marion County Coroner and is still undetermined.

The FAA Civil Aerospace Medical Institute performed forensic toxicology on specimens from the pilot. Results were negative for carbon monoxide, ethanol, and drugs.

The pilot was wearing a helmet similar to a Comtronics Aircraft Helmet. However, its make and model could not be verified.

The gyroplane was recovered to a hanger and examined by the FAA inspector. They found that the belt driving the prerotator had broken and had become entangled in the timing belt. No other anomalies were detected with the airframe and engine. The gyroplane's prerotator had a freewheeling mechanism which would allow for free rotation of the rotor system. In addition, the prerotator would not have been engage during the accident.