N421TKCessna 421C · 1979

On April 25, 2017, about 1038 central daylight time, a Cessna 421C airplane, N421TK, impacted trees and terrain near Huntsville, Texas. The commercial pilot was fatally injured, and the airplane was destroyed by impact forces and a postcrash fire. The airplane was registered to Klass Enterprises, LLC, and operated by the pilot under the provisions of 14 Code of Federal Regulations Part 91. Day visual meteorological conditions (VMC) prevailed and no flight plan was filed for the postmaintenance test flight, which originated from Lone Star Executive Airport (CXO), Conroe, Texas, about 0952.

The pilot was receiving visual flight rules (VFR) flight-following services from Houston Terminal Radar Approach Control (TRACON) and intended to conduct a practice RNAV approach at CXO. At 1030, about 38 minutes after departure, at an altitude about 2,400 ft mean sea level (msl), the pilot reported an oil leak and requested to proceed directly to the airport. The controller advised that Huntsville Municipal Airport (UTS), Huntsville, Texas, was closer, and the pilot elected to proceed to UTS. The controller then issued a heading to position the airplane for a right base leg for runway 18 and stated that the airport was at the pilot's 1-o'clock position, 7 miles away. The pilot acknowledged and turned the airplane onto the issued heading. Radar data indicated that, about 1030:05, the airplane began a left turn to a heading about 70°. This heading would have taken the airplane about 2 miles north of the approach end of runway 18 at UTS. During the turn, the airplane began to descend, with the final radar data point recorded at 1032:39 about 3.5 miles and 290° from UTS. The final recorded pressure altitude was 2,000 ft msl.

At 1033, the controller told the pilot that he was vectoring the airplane north of the airport for landing on runway 18. The pilot stated that he did not have the airport in sight; the controller replied that it was at his 2-o'clock position and 3 miles. The pilot again reported that he did not have the airport in sight.

At 1035, the controller lost communication and radar contact with the accident airplane. After losing communications, the controller used another aircraft to relay to the accident pilot that he had flown past UTS. The accident pilot reported via the relay aircraft that he did not have the airport in sight and that his airplane's engine was "dead." The relay aircraft made several subsequent attempts to communicate with the accident pilot but was unsuccessful.

A witness, who was an off-duty police officer, reported seeing the airplane flying in a westerly direction about 150 ft above the ground. He said that the airplane banked left about 45° and he noticed that the left propeller was not turning and that the airplane was losing altitude. Suspecting a problem, the officer got into his car; he then heard the operating engine either "idle down" or shut off completely. The airplane then went out of sight behind a tree line and the officer saw a large plume of smoke. The officer added that, when the airplane passed over his residence, the wing flaps appeared to be retracted or at a very low angle, and the landing gear was in the retracted position. He noted that the right engine did not sound as though it was sputtering or experiencing difficulties until he heard the engine sound decrease. He further noted that he did not see any smoke coming from the airplane as it passed overhead.

The 62-year-old pilot held a commercial pilot certificate with airplane single-engine land and instrument airplane ratings. The certificate also listed airplane multi-engine land and rotorcraft-helicopter ratings limited to private pilot privileges. The pilot was issued a Federal Aviation Administration (FAA) third-class airman medical certificate on July 27, 2016, with a restriction for corrective lenses.

The pilot had logged about 1,567 total hours of flight experience, with about 219 hours in the accident airplane. The pilot's logbook indicated that he had received 8.8 hours of instruction in a Cessna 421C simulator at SIMCOM Aviation Training Center. The logbook also indicated that he met the requirement for a flight review based on successful completion of the helicopter private pilot practical test on February 22, 2017.

The accident airplane was a 1979 Cessna 421C, serial number 421C0601. It was an eight-place, low-wing, twin-engine airplane with retractable tricycle landing gear. The airplane was issued an FAA normal category standard airworthiness certificate on September 27, 1978. The airplane was powered by two 375-horsepower Continental Motors GTSIO-520L six-cylinder, turbo-supercharged reciprocating engines.

According to the airplane maintenance records, the airframe had accumulated 7,647.3 hours total time in service at the time of the most recent annual inspection dated April 24, 2017. The left engine, serial number 276375, had accumulated 3,606.1 hours total time in service and 132.0 hours since overhaul as of the most recent annual inspection. The right engine, serial number 808287, had accumulated 2,627.4 hours total time in service and 381.4 hours since overhaul as of the most recent annual inspection. The annual inspection was the last recorded maintenance performed on the airplane.

The 1053 weather conditions recorded by the UTS Automated Surface Observing System, located about 4 miles southwest of the accident site, included: wind from 170° at 12 knots gusting to 17 knots, visibility 10 miles, clear skies, temperature 24°C, dew point 18°C, and an altimeter setting of 29.69 inches of mercury.

The accident airplane was a 1979 Cessna 421C, serial number 421C0601. It was an eight-place, low-wing, twin-engine airplane with retractable tricycle landing gear. The airplane was issued an FAA normal category standard airworthiness certificate on September 27, 1978. The airplane was powered by two 375-horsepower Continental Motors GTSIO-520L six-cylinder, turbo-supercharged reciprocating engines.

According to the airplane maintenance records, the airframe had accumulated 7,647.3 hours total time in service at the time of the most recent annual inspection dated April 24, 2017. The left engine, serial number 276375, had accumulated 3,606.1 hours total time in service and 132.0 hours since overhaul as of the most recent annual inspection. The right engine, serial number 808287, had accumulated 2,627.4 hours total time in service and 381.4 hours since overhaul as of the most recent annual inspection. The annual inspection was the last recorded maintenance performed on the airplane.

The airplane impacted trees and terrain before coming to rest inverted in a shallow ranch pond. The lower portion of the fuselage and the wings remained above the surface of the water and showed evidence of fire damage. Based on the initial tree impact and the resting place of the wreckage, the airplane was traveling in a southerly direction when the impact occurred. On-scene examination of the airplane was not possible due to its location in the pond, and further examination was conducted after removal from the accident site.

The subsequent examination of the airframe and the right engine did not reveal any anomalies consistent with a preimpact failure or malfunction. The left engine exhibited a protruding bulge in the engine case. Subsequent teardown examination of the left engine revealed that the No. 2 connecting rod had separated from the crankshaft. The connecting rod journal on the crankshaft had heat damage and discoloration. Crankshaft rod journals Nos. 1, 3, and 4 exhibited heat discoloration, but their respective connecting rods remained attached to the crankshaft. The engine oil pump was intact and was disassembled; the gears were covered with oil. No source for an oil leak was discovered, and no additional anomalies consistent with a preimpact failure or malfunction were found.

The Montgomery County Forensic Services Department, Conroe, Texas, performed an autopsy on the pilot. The cause of death was attributed to injuries received in the accident.

The FAA Bioaeronautical Sciences Research Laboratory, Oklahoma City, Oklahoma, performed toxicology testing on specimens of the pilot. Atorvastatin, a non-impairing prescription medication used to treat high cholesterol, was detected in urine and blood specimens.