N4426C is a 1953 Cessna 195. It is a fixed-wing single-engine aircraft with 5 seats, powered by a Jacobs R755A series rated at 300 horsepower. The registration is active, with the registrant based in Fredericksburg, TX. Its standard airworthiness certificate was issued in Jan 1956. It has been registered to its current owner since Feb 2008. This page also carries 2 NTSB events.
- 73 years old
- 1 of 213 Cessna 195
2008
1956
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N4426C's record changes.
On February 16, 2013, about 2145 central standard time, a Cessna model 195 airplane, N4426C, was substantially damaged while taxiing at the Austin Executive Airport (EDC), Austin, Texas. The private pilot and passenger were not injured. The airplane was registered to and operated by the pilot, under the provisions of 14 Code of Federal Regulations Part 91, without a flight plan. Night visual meteorological conditions prevailed for the personal flight. The flight had the intended destination of Gillespie County Airport (T82), Fredericksburg, Texas.The pilot reported that the accident occurred as he was taxiing on the unlit taxiway that paralleled runway 13-31. As the airplane approached the end of the taxiway, adjacent to the runway 13 threshold, the right wing landing light became inoperable, significantly reducing the pilot's forward visibility in the dark night conditions. The pilot cycled the right wing landing light switch as he applied wheel brakes; however, the light did not illuminate. The pilot stated that he was unable to stop the airplane before it departed the end of the taxiway and traveled down an embankment. He did not recall seeing any reflective markers identifying the end of the taxiway. Although the airplane was equipped with two landing lights, one on each wing, the pilot reported that he avoided using both lights simultaneously during taxi operations because such use rapidly depletes the battery charge at the lower engine power settings required to taxi.
According to information provided by the EDC airport manager, the unlit taxiway that serviced runway 13-31 was marked with blue reflective posts that were 24-inches tall. These blue reflective posts were spaced at 31-foot intervals along the taxiway edges only. The end of the taxiway was identified by red reflectors that were installed at ground level. Additionally, an airport survey plot indicated that there was a 16-foot descending embankment, specified to have a 3:1 graded slope, located immediately adjacent to the northwest end of the taxiway and the runway 13 threshold. The use of reflective posts to identify the taxiway and the descending embankment were not identified in the Federal Aviation Administration (FAA) Airport Facility Directory.
According to the FAA Airplane Flying Handbook, the requirements for safe taxi operations include the ability to recognize potential hazards in time to avoid them, as well as the ability to stop or turn where and when desired. The handbook further stipulates that taxi speeds should be slow enough that the airplane can be stopped promptly and "without undue reliance on the brakes."
At 2155, the airport's automated surface observing system reported: wind 210 degrees true at 4 knots, visibility 10 miles, sky clear, temperature 8 degrees Celsius, dew point -3 degrees Celsius, and an altimeter setting 30.24 inches of mercury.
The United States Naval Observatory reported that sunset and end of civil twilight at the airport on the night of the accident occurred at 1820 and 1844, respectively. At 2145, the waxing crescent moon was visible to the west of airport, located about 36 degrees above the horizon, with about 44 percent of the moon's visible disk illuminated. The moonset occurred about 3 hours after the accident at 0046.
In response to the accident, the airport authority agreed to purchase additional blue reflective posts to more adequately mark the limits of the unlit taxiway. Additionally, the FAA agreed to amend its Airport Facility Directory to reflect that the taxiway edges were marked by reflector posts and that the northwest end of runway 13-31 and parallel taxiway had a 16-foot descending embankment beginning at the end of the pavement.
On June 23, 2008, approximately 0815 central daylight time, a Cessna 195, N4426C, piloted by a private pilot, was substantially damaged when the right main landing gear collapsed during landing at the West Houston Airport (IWS), Houston, Texas. Visual meteorological conditions prevailed at the time of the accident. The personal flight was being conducted under the provisions of Title 14 Code of Federal Regulations (CFR) Part 91 without a flight plan. The pilot and his passenger were not injured. The cross-country flight originated at Fredericksburg (T82), Texas, approximately 0645, and was en route to Houston.
According to the pilot's accident report, he made a "smooth wheel landing" on runway 33. Touchdown speed was 80 mph. After the tail wheel settled to the ground, the pilot applied brakes and the airplane started veering to the left. The pilot attempted corrective action, but the airplane started to ground loop. The pilot said side loads on the right main gear caused the wheel to break off. The gear strut dug into the ground and it, too, broke off.
According to an FAA inspector who went to the accident site, the right main wheel was still attached to the landing gear strut. The leading edge of the left wing was crushed from the tip to the root, both elevators were bent, and the firewall was wrinkled. There was no evidence of pre-existing failure or malfunction of the airplane or flight controls. The weather was clear and the winds were calm.
No photos yet. Sign in to add the first one.