N4594JPiper PA-28R-180 · 1968

On July 23, 2017, about 1247 Pacific daylight time, a Piper PA-28R-180, N4594J, was substantially damaged during takeoff from the Reid-Hillview Airport (RHV), San Jose, California. The commercial pilot, sole occupant of the airplane, was not injured. The airplane was registered to Foluain Fabhcun LLC., Aptos, California, and operated by the pilot under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed and no flight plan was filed for the cross-country flight, which was originating at the time of the accident with an intended destination of Marina, California.

The pilot reported that the airplane had just had extensive maintenance performed, which included installation of several avionics upgrades, and right seat brake pedals; the accident flight was the first flight since the maintenance had been completed. During takeoff on runway 31R, as the airplane became airborne at an airspeed of about 80 miles per hour, it immediately entered an uncommanded roll to the left. The pilot said that he attempted to correct for the roll; however, he was unable to, and instead reduced engine power. Subsequently, the airplane impacted the ground and came to rest upright on runway 31L.

Examination of the airplane by a Federal Aviation Administration inspector revealed that the fuselage and left wing were structurally damaged.

Examination of the airplane by the National Transportation Safety Board investigator-in-charge revealed that when the control yoke was rotated for input of right aileron, the left aileron moved upward and the right aileron moved downward. Examination of the aileron cables revealed that they remained attached to the "T" bar aileron control chains. The right aileron control cable was attached to the left side aileron control chain and the left aileron control cable was attached to the right-side aileron control chain. The cables were oriented in a nature that they crossed underneath the flap handle and center console area.

During a telephone conversation with one of the two mechanics that had worked on the airplane prior to the accident flight, he reported that he performed an oil change along with various other work while another mechanic was installing a second set of rudder pedals with brake controls on the right seat side of the airplane. In addition, the mechanic stated that he checked the airplane for flight control cable tension, noting that the operation was smooth, and visually looked at the ailerons while he was moving the control yoke. He added that at no time did he noticed that the aileron cables were installed backwards. The mechanic further reported that all work on the airplane was performed in accordance with the Piper Aircraft Maintenance Manual.

The second mechanic reported that he disconnected aileron cables to facilitate installation of rudder pedals and brake assemblies, and subsequently reattached the aileron cables. The mechanic stated that he did not observe the ailerons while the other mechanic checked aileron control deflections.

During a telephone conversation with the pilot, he reported that prior to the flight, he performed a walk around inspection of the airplane and recalled that he moved the ailerons, but did not verify which direction the control yoke moved. In addition, he said that prior to takeoff, he checked the movement of all the flight controls, but did not verify which direction the ailerons moved when he moved the control yoke. The pilot stated that his primary focus was on the rudder and brakes as they were recently worked on.