N473GF is a 1967 Cessna 305A. It is a fixed-wing single-engine aircraft with 2 seats, powered by a Cont Motor O-470 series rated at 230 horsepower. The registration is active, with the registrant based in Waialua, HI. Its standard airworthiness certificate was issued in Dec 1967. It has been registered to its current owner since Oct 1976. This page also carries 1 NTSB event.
- 59 years old
- 1 of 169 Cessna 305A
1976
1967
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N473GF's record changes.
On February 16, 2008, at 1245 Hawaiian standard time, a Cessna 305-A, N473GF, experienced a left main landing gear collapse during a crosswind landing at Dillingham Airfield, Mokuleia, Hawaii. The airplane was operated by the Honolulu Soaring Club under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The airline transport certificated pilot was not injured, and the airplane was substantially damaged. Visual meteorological conditions prevailed, and no flight plan had been filed. The local flight originated at Dillingham Airfield at 1230.
The pilot reported that he observed the windsocks at each end of runway 8/26, and both indicated tail winds of about 10 knots in either direction. The midfield windsock indicated a direct crosswind from the north. He elected to approach runway 8 and touched down abeam the midfield windsock. Upon touchdown the airplane experienced a left-to-right crosswind, and as the airplane decelerated, the pilot noticed the wind shift to a quartering right tail wind. He elected to execute a go-around. As he advanced the throttle, the engine sputtered, the left main landing gear collapsed, and the airplane ground looped to the left as it approached the runway's edge.
A Federal Aviation Administration inspector examined the left main landing gear spring strut and found that the strut separated where the wheel bolts to the strut. The fracture face of the strut was granular in texture and uniform matte gray in color. When the fracture surface of the landing gear strut section that remained attached to the wheel was more closely examined, it exhibited an approximate 1/16 inch flat dark triangular section at the corner of the mounting bolt hole. The Safety Board Materials Laboratory examination confirmed the presence of a 0.072 inch fatigue crack at this location.
No photos yet. Sign in to add the first one.