N496AEBell 407 · 1999

On November 2, 2015, at 1923 central standard time, the pilot of a Bell 407, N496AE, made a forced landing at San Antonio International Airport (KSAT), San Antonio, Texas. The pilot, flight nurse, and paramedic were not injured. The helicopter was substantially damaged. The helicopter was registered to and operated by AirEvac EMS, Inc., (EVCA), O'Fallon, Missouri, under the provisions of 14 Code of Federal Regulations Part 135 as an on-demand air medical flight. Night visual meteorological conditions prevailed at the time of the accident, and no flight plan had been filed. The flight was originating from KSAT, and was destined for Northeast Methodist Hospital (XS83), San Antonio.

When the pilot lifted helicopter to a 3-foot hover, he heard a loud bang and the helicopter began an uncommanded right yaw. The pilot applied full left pedal, but this did not arrest the yaw. The pilot then lowered the collective and the helicopter touched down, rotating 270 degrees to the right before coming to a stop. Post-accident examination revealed substantial damage to the tail rotor spline, coupling, and hanger bearings.

Postaccident examination revealed the tail rotor could be manually rotated, but a grinding noise could be heard coming from the damaged no. 3 hanger bearing. The main rotor blades did not rotate in synchronization with the tail rotor blades. The #3 tail rotor shaft adapter and shaft splines were completely ground down, and the adapter and the tail rotor shaft connecting point had failed. There was evidence of excessive torsion, beyond its intended allowable tolerances. There was excessive grease on the hanger bearing. The aluminum adapter washer hole was elongated, consistent with of a loose through-bolt. There was a 1/8th inch gap between the adapter and the base of the hanger bearing, consistent with the adapter not being fully in contact with the bearing and potential stress within the adapter and shaft splines. The smaller, stainless steel washer was mushroom-shaped. The drive shaft through-bolt had worn threads.

On November 18 and 19, 2105, the tail rotor assembly was examined at the facilities of Able Engineering, Mesa, Arizona, under the auspices of an FAA aviation safety inspector from the Scottsdale, Arizona, FSDO. Bell Helicopters and AirEvac EMS also participated in the examination. The shaft, freewheeling unit and tail gear box were examined. No issues were noted except for the failed coupling and shaft. The retaining stud had migrated almost .025" outward and was very loose compared to the others, consistent with the loss of torque that would have allowed movement between the coupling and shaft and eventual failure.

After the examination, Air Evac EMS ordered an inspection of their entire Bell 407 fleet. Two helicopters were found to have loose tail rotor drive shafts. The drive shaft, carrier bearing, coupling, and spline from one of those helicopters were examined the next day. The retaining nut was loose. Torque was measured at 20 inch-pounds. Minimum torque is 30 to 50 inch-pounds. Tare was 5 to 0 inch-pounds. Stud extension was within millimeter limits. There was a slight motion between the coupling face and the face of the bearing. This motion had worn the coupling face and there was slight wear on some of the splines. In the Bell 407 Maintenance Manual and Air Evac EMS' AAIP, there is no requirement for the assembly to be inspected for security.