N497DACirrus Design SR20 · 2007

During the supervised solo flight, the student pilot had completed three previous circuits in the traffic pattern, with two of the three landing attempts aborted. On the fourth landing attempt, a 70-degree right crosswind "blew" the airplane off the left side of the runway. The student pilot then applied full engine power to conduct a go-around, and the airplane "veered left and banked 45 degrees to the left." The student pilot stated that the airplane continued left "no matter how hard I pushed the control stick to the right." The student pilot also reported that there were no mechanical deficiencies with the airplane that would have prevented normal operation. According to FAA Advisory Circular AC-61-23C, Pilot's Handbook of Aeronautical Knowledge:

"The effect of torque increases in direct proportion to engine power, airspeed, and airplane attitude. If the power setting is high, the airspeed slow, and the angle of attack high, the effect of torque is greater. During takeoffs and climbs, when the effect of torque is most pronounced, the pilot must apply sufficient right rudder pressure to counteract the left-turning tendency and maintain a straight takeoff path."

According to the pilot, while in the vicinity of an unfamiliar airport, he utilized his global positioning system (GPS) to align the airplane with the runway. During the landing roll, while impacting mailboxes and fences, the pilot realized he had landed on a residential street. The runway was about one and a one-half miles to the west. According to a representative of the flight school, the standard operating procedure required all pilots to utilize the GPS for all approaches. The representative further stated that there were no mechanical malfunctions or failures with the airplane. According to a Federal Aviation Administration inspector that responded to the accident location, the wings sustained substantial damage.