N525KTCessna 525C · 2011

On December 27, 2017, at 0650 central standard time, a Cessna 525A airplane, N525KT, impacted an airport fence, highway barrier, and terrain during a landing overrun on runway 20 (4,100 ft by 75 ft, asphalt/dry snow) following an area navigation (RNAV) runway 20 approach at Michigan City Municipal Airport-Phillips Field (MGC), Michigan City, Indiana. The airplane sustained substantial damage. The pilot and copilot received minor injuries. The airplane was registered to Van E Aviation LLC and operated by Integrated Flight Resources Inc under 14 Code of Federal Regulations Part 91 as a positioning flight and was operating on an activated instrument flight rules flight plan. The flight originated from DuPage Airport (DPA), West Chicago, Illinois, at 0622 and was destined to MGC for a Part 135 on-demand passenger flight.

The pilot stated the co-pilot was the flying pilot for the flight. About halfway to MGC, they noticed instrument meteorological conditions below them. They flew the MGC RNAV approach runway 20 and broke out of the clouds with "adequate time to see the runway lights." The pilot said the runway appeared to have a "light dusting of snow." He said the airplane touched down on speed within the first 1,000 ft of the runway. The co-pilot "immediately" deployed ground flaps, and the airplane began slowing down. There appeared to be no braking effectiveness when co-pilot braked "heavily." He said the airplane was not slowing down as he was accustomed. About 2/3rds down, he knew that the airplane was going to overrun the runway, and the airplane had not lost half its airspeed. He said there was a small chance to become airborne within the remaining runway distance if an aborted landing was performed. The pilot said that engine power was added for the aborted landing, and for a moment it appeared that the airplane was going to become airborne as the nose wheel landing gear lifted off, but there was not enough runway remaining. Engine power was reduced to idle as the airplane overran the runway and went through the airport fence, a guard rail, across US Highway 20, and into a field.

A witness, who was driving westbound in the right lane of US Highway 20, stated he saw the airplane traveling toward the north, go through the fence and guard rail, and missed his car by no more than 5 ft.

The airplane came to rest, facing north, in a corn field about 300 yards from the departure end of the runway 20. The left wing was separated near wing station (WS) 57.00 and the right wing leading edge sustained damage near WS 171.00. The vertical stabilizer sustained damage near water line 195.00. A post-accident examination revealed that there were no flat spots or evidence of skidding on the landing gear tires. The flaps were in the GROUND FLAPS POSITION. There were no mechanical anomalies that would have precluded normal aircraft operation.

According to the airport manager, the soonest that airport personnel could perform a post-accident runway inspection was about two hours after the accident and it revealed about ¼ inch of snow on the runway.

The Cessna 525A Aircraft Flight Manual shows an airplane at the gross landing weight (12,500 lbs) and weather conditions, the airplane needed about 2,540 ft to stop on a dry runway. The 525A Section VII Advisory Information indicates that the stopping distance with 1 inch of snow was 7,100 ft and with 2 inches of snow was 6,300 ft.

According to the Federal Aviation Administration inspector from the DuPage Flight Standards District Office, the approximate stopping distance on a wet runway based upon an aircraft weight of 11,000 lbs was 4,400 ft. An alternate airport required under Part 91.169(a)(2), IFR flight plan: Information required, was not filed by the flight crew.