N55455Piper PA-32-260 · 1973

On January 25, 2020, about 0930 eastern standard time, a Piper PA32-260, N55455, was destroyed when was involved in an accident near Lake City, Florida. The private pilot was fatally injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

A witness stated that the pilot flew to Cannon Creek Airpark (15FL), Lake City, Florida, the weekend before the accident. At that time, the pilot said the engine “cut out” on short final approach to the runway; however, after landing, the pilot performed an engine run-up, and the engine performed normally. The pilot and the witness subsequently opened the engine cowling and observed an oil leak. The pilot contacted a local mechanic to fix the oil leak. A couple of days later, the pilot ran the engine, and no oil leaks were noted. The night before the accident flight, the pilot and the witness taxied the airplane to the fuel tank and topped off the wing tanks and left-wing tip tank, but they did not put fuel in the right-wing tip tank because it had a fuel leak.

On the morning of the accident, the witness and pilot performed a preflight inspection of the airplane and noted no anomalies. The witness watched the airplane take off from runway 36 and noticed that the pilot “turned hard left” after the airplane cleared the trees, which was earlier than normal. The witness returned to his vehicle when he heard a loud bang and saw smoke. He drove over to the smoke and saw that the airplane was engulfed in flames.

The airplane came to rest on the side of a house in a subdivision about 1,000 ft to the west side of the midpoint of the runway. The wreckage was oriented on a heading of 215° and there was no discernable horizontal wreckage path. A postaccident fire consumed the airplane, and only the tail section remained intact and undamaged by fire. The cockpit, instrument panel, firewall, fuselage, and wings were all destroyed by the fire, and the engine accessory case was consumed by fire; the magnetos, fuel pump, carburetor, vacuum pump, and oil filter were destroyed. All major components of the airplane were accounted for at the scene. Control cable continuity was confirmed to the respective controls.

Postaccident examination of the engine revealed the engine crankcase and cylinders were intact. The top spark plugs were removed, and a borescope examination of the cylinder walls, exhaust, intake valves and piston heads revealed no anomalies. The engine’s crankshaft was rotated by hand and thumb compression was established on all cylinders. Valve train continuity was established throughout the engine by observing movement of the rocker arms and rear accessory case gears.

Both propeller blades remained attached to the hub. One blade was bent aft about midblade, and both blades were twisted near the tip.

A witness near the airport captured the airplane engine noise on a video camera. The airplane was not captured by the video, and its position, ground track, speed, and therefore at what point during the accident sequence the captured audio occurred could not be determined. A sound spectrum analysis of the audio by the National Transportation Safety Board Vehicle Recorders Laboratory revealed that during the time audio from the accident airplane’s engine was recorded, the engine rpm was approximately 2,584 rpm, which was slightly below the maximum rated 2,700 rpm.

An autopsy performed on the pilot by the Office of the Office of the Medical Examiner, Jacksonville, Florida, reported the cause of death as blunt force trauma.

Toxicology testing performed at the FAA Forensic Sciences Laboratory found no tested-for drugs or alcohol.