N5562QMooney M20E · 1965

On January 17, 2018, about 1130 Pacific standard time, a Mooney M20E airplane, N5562Q, was substantially damaged when it crashed in a parking lot near Skyforest, California. The private pilot received serious injuries, and one passenger received minor injuries; the other two passengers were not injured. The airplane was registered to Tangobravo Consulting LLC., Redlands, California, and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed, and no flight plan was filed. The flight originated from San Bernardino International Airport (SBD), San Bernardino, California, about 1100 and was destined for Black Bear, California.

The pilot reported that he departed SBD with 20 gallons of fuel onboard. About 5 minutes into the flight and approximately 3 miles northwest of SBD, the airplane approached rising terrain that ascended from about 1,800 ft to 5,700 ft over approximately 5.5 miles. The airplane was about 1,000 ft above ground level (AGL) as it neared the top of the ridgeline. According to the pilot's recount, about that time the airplane encountered a down draft and then aerodynamically stalled, which was immediately followed by an impact with terrain.

According to one of the passengers, he heard three lengthened aural warnings prior to impact that were later determined to be the airplane's stall warning horn. The first lasted about 4 to 5 seconds, the second lasted about 3 to 4 seconds, and the third started as they crested the ridge and continued until impact.

A surveillance video from Santa's Village captured the airplane's final movements and showed it in straight and level flight from the southwest about 25 ft AGL. As the airplane moved into the center of the video frame, its pitch attitude increased, followed by a quick descent. The airplane impacted the ground right wing first, then spun around to the right and came to rest in the parking lot. (see figure 1)

Figure 1- Accident Diagram.

The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

The pilot did not submit the National Transportation Safety Board Pilot/Operator Aircraft Accident/Incident Report Form 6120.1.

The 1149 recorded weather observation at SBD, located about 9 nm southwest of the accident site, included wind calm, visibility 7 statute miles, scattered ceiling 15,000 ft, temperature 23° C, dew point 1° C, and an altimeter setting of 30.19 inches of mercury. The calculated density altitude at the accident site was about 6,550 ft.

Airplane Weight & Balance

According to the airplane's most recent weight and balance calculation sheet, the airplane had an empty weight of 1,629.1 lbs., and a maximum gross weight of 2,575 lbs. The airplane's weight & balance was calculated with a pilot and front seat passenger's weight of 380 lbs., a rear seat passenger's weight of 390 lbs., and 120 lbs. of fuel. The weight of the airplane at the time of the accident was about 2,519.1 lbs., and the center of gravity (CG) was about 42.66 inches.

Calculations using the occupants' weight resulted in a gross weight below the maximum allowable, but with CG values about 4 inches forward of the allowable envelope. (See weight and balance calculation sheet in docket for more information)

Forward CG

The FAA Pilot's Handbook of Aeronautical Knowledge states,

"The aircraft stalls at a higher speed with a forward CG location. This is because the stalling AOA [angle of attack] is reached at a higher speed due to increased wing loading."

Mountain Flying

Excerpts from FAA-P-8740-60, Tips on Mountain Flying stated the following:

Effects on Performance

At higher density altitudes, takeoff and landing distances are increased, rate of climb and actual service ceiling are decreased, true airspeed is higher for a given indicated airspeed, and turning radius is larger at high altitude at a given indicated airspeed. To help regain some of the lost takeoff and landing performance at high density altitudes, you should reduce the weight at which you fly the airplane to no more than 90% of maximum gross weight.

Ridge and Pass Crossing

On most mountain flights, you will need to cross at least one ridge or pass. Experienced pilots recommend crossing a ridge or pass at the ridge elevation plus at least 1,000 feet. If the winds at mountain top level are above 20 knots, increase that to 2,000 feet. Plan to be at that altitude at least three miles before reaching the ridge and stay at that altitude until at least three miles past it. This clearance zone will give you a reasonable safety zone to avoid the most severe turbulence and down drafts in windy conditions.