N619AC is a 1977 Cessna 421C. It is a fixed-wing multi-engine aircraft with 8 seats, powered by a Cont Motor GTSI0-520-F-K rated at 435 horsepower. The registration is active, with the registrant based in Amarillo, TX. Its standard airworthiness certificate was issued in Aug 1977. It has been registered to its current owner since Dec 2023. This page also carries 1 NTSB event.
- 49 years old
- 1 of 513 Cessna 421C
2023
1977
That's everything on file so far — TailWiki checks the FAA registry daily and adds new entries as N619AC's record changes.
On May 15, 2022, about 1320 central daylight time, a Cessna 421C, N619AC, was substantially damaged when it was involved in an accident near Monroe, Louisiana. The pilot and five passengers were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
The pilot stated that immediately after departure from Morehouse Memorial Airport (BQP), Bastrop, Louisiana, he heard a loud pop and the control yoke oscillated violently. He declared an emergency and diverted to Monroe Regional Airport (MLU), Monroe, Louisiana, about 16 miles southwest, for a longer runway and emergency services. The control yoke and airplane continued to oscillate until the airplane was on final approach, about 3 miles from MLU, then the oscillation stopped. The pilot landed the airplane without further incident.
A postaccident examination of the airplane revealed that the right elevator had mostly separated from the horizontal stabilizer and only a small portion of the inboard elevator remained attached. There was a small puncture on the right side of the rudder.
The elevator trim push-pull rube remained attached to the trim actuator; however, there was no bolt, nut, or cotter pin attached to the aft fork connection, and the trim tab was missing. The push-pull tube did not exhibit any preaccident damage or anomalies. The remainder of right elevator and trim tab were not located.
A review of the airplane’s maintenance logbooks revealed that the elevator trim system was re-rigged on May 13, 2022, two days before the accident. The maintenance personnel who completed the work and signed off on the logbook stated that he did not ensure that the push-pull tube hardware was reinstalled. He added that he checked everything else but missed that step. The airplane had accumulated about 4 hours of flight time since the elevator trim maintenance was completed.
As a result of the accident, the maintenance facility updated their company practices to include a secondary inspection sign-off and updated their work order close out procedures.
No photos yet. Sign in to add the first one.