N6521YPiper PA-23-250 · 1967

On April 30, 2020, about 1200, Pacific daylight time, a Piper PA-23-250 airplane, N6521Y, was substantially damaged when it was involved in an accident near Hemet, California. The pilot was fatally injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 aerial survey flight.

According to a fellow company pilot flying a similar mission in the area, the accident pilot was tasked to photograph two parcels of land, identified as flight plan 223 (FP223), and flight plan 224 (FP224). The flight plans were to be flown north to south, at 8,500 ft msl +/- 300 ft mean sea level (msl), and at 120 to 130 knots groundspeed.

Examination of recorded camera data revealed the pilot had selected FP224 to photograph first. Prior to entering FP224, the pilot communicated with a fellow company pilot and stated that he was “about to be on station.” At a time between 1140 and 1210, the pilot made two distress radio calls.

Recorded automatic dependent surveillance-broadcast (ADS-B) data revealed the accident airplane departed CNO about 1131, climbed to an altitude of about 8,500 ft msl, established a ground speed of about 164 knots, and tracked southeast for about 42 miles. About 5 miles northwest of Diamond Valley Lake, the airplane descended to 8100 ft and decelerated to 130 knots before turning east. The airplane proceeded eastward for about 15 miles, passing near a Camp, a cleared area with several buildings located at the base of a valley. The airplane continued east for about 3 miles, then turned north, consistent with tracking toward the FP224’s southern boundary. About 1 minute later, and prior to entering FP224, the airplane began a left turn and a descent. During the left turn, the airplane traversed through FP223 to the southwest and maintained the new heading for about 3.5 miles, until crossing over the Camp again. From there, the airplane began a right turn and continued to descend. The last data point recorded at 1200, revealed the airplane about 4,400 ft mean sea level (msl), or 1,000 ft above ground level (agl), about 177 knots ground speed, and about 950 ft northeast of the accident site. Figure 1 shows the ADS-B derived flightpath.

Figure 1. Capture of ADS-B data. The blue arrows show the direction of flight.

Data captured from the onboard camera system recorded the entire flight and provided time, location, and flight data consistent with the ADS-B data. At 1200:02, the camera system revealed the airplane to be in a 31° nose-down attitude, and a 79° right roll. At 1158:02, the camera system recorded the airplane to be at 7,158 ft msl, 4°nose down, 11° right roll, and 150 knots.

The airplane was manufactured in 1967. According to the operator the airplane was maintained under an annual maintenance program. The last annual inspection occurred on November 21, 2019.

The airplane was modified in April 1994 to carry a Kodak Hite experimental camera system that was later changed to an Eagleview proprietary digital camera. The camera system recorded airplane flight parameters including pitch, roll, altitude, heading and speed.

The airplane was manufactured in 1967. According to the operator the airplane was maintained under an annual maintenance program. The last annual inspection occurred on November 21, 2019.

The airplane was modified in April 1994 to carry a Kodak Hite experimental camera system that was later changed to an Eagleview proprietary digital camera. The camera system recorded airplane flight parameters including pitch, roll, altitude, heading and speed.

Examination of the accident site revealed that the airplane impacted steep mountainous terrain and came to rest inverted about 15 miles west of the intended aerial survey area. The debris path was about 240 ft in length, oriented downhill on a heading of about 239°. The first identified point of impact was a shallow indentation in sandy soil at the top of the ridgeline at an altitude of 3,606 ft MSL.

The fuselage exhibited substantial damage throughout its entirety.

The right propeller was not found at the accident site. Examination of the fracture site was consistent with overload separation.

Post-accident visual examination of the aileron control cable exhibited multiple broken wires protruding from the strands and a separation fracture located between the left aileron bellcrank and the cable junction for the control yokes. Examination of the cable by the NTSB materials laboratory revealed the cable consisted of six strands wrapped about a central core strand. All the strands had fractured in approximately the same location, perpendicular to the cable direction. Two of the strands exhibited little fraying of the wires, whereas the other four exhibited local fraying upwards of 0.5 inch from the fracture surface. The core strand exhibited fraying several inches from the fracture surface. Further examination revealed numerous wires fractured by overload and others fractured by fatigue, with some cracked by fatigue and then fractured by overload. Figure 2 is showing the fracture of the aileron cable, and Figure 3 is showing an example of the broken wires on the aileron control cable.

Figure 2. View of the aileron control cable.

Figure 3. The aileron control cable, showing frayed wires.

Piper Aztec service manual Annual/100 Hour Inspection Procedure states in part,

F. Wing group.

Note 9. Examine cables for broken strands by wiping them with a cloth for the entire length. Visually inspect the cable thoroughly for damage not detected by the cloth. Replace any damaged or frayed cables.

Toxicology testing performed by the FAA Forensic Sciences Laboratory detected tetrahydrocannabinol (THC), the primary psychoactive compound in cannabis, and its primary metabolite11-hydroxy-delta-9-THC in the pilot’s urine at 0.9 nanograms per milliliter (ng/mL) and 12.3 ng/mL, respectively; neither were detected in his cavity blood or liver tissue. THC’s inactive metabolite carboxy-delta-9-tetrahydrocannabinol (THC-COOH) was detected in the pilot’s cavity blood, urine, and liver tissue at 7.1 ng/mL, 89.9 ng/mL, and 376.2 nanograms per gram, respectively. Toxicology testing performed for the coroner’s office was positive for

cannabinoids in the pilot’s blood.