N656BNWilliam E Mcclain CH750 CRUZER · 2018

On September 10, 2020, about 1243 central daylight time, an experimental amateur-built Zenair CH750 Cruzer airplane, N656BN, was substantially damaged when it was involved in an accident near Boaz, Alabama. The pilot was fatally injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

On the day of the accident, the pilot planned to fly from Tom B. David Airport (CZL), Calhoun, Georgia; to Tupelo Regional Airport (TUP), Tupelo, Mississippi; from TUP to Northeast Alabama Regional Airport (GAD), Gadsden, Alabama; and from GAD to CZL. According to a family member, this flight was a "test run" for a flight that the pilot planned to conduct on September 14 from CZL to Conway Regional Airport at Cantrell Field (CXW), Conway, Arkansas. The family member also stated that the pilot had not previously flown to CXW and that he thought that the flight from CZL to TUP would be a “good test” because the flight to TUP was about one-half the distance to CXW.

Before the flight from CZL to TUP, the pilot had topped off the fuel tanks in the airplane. Radar data and automatic dependent surveillance--broadcast data revealed that the airplane departed runway 25 at CZL about 0917 and then turned westbound until it was about 6 nautical miles (nm) east of TUP (near the area of Mooresville, Mississippi). The data also showed that the airplane then reversed course and flew east-southeast in the general direction of GAD at varying altitudes from about 2,500 to 5,400 ft mean sea level (msl) during cruise flight.

As the airplane passed Nectar, Alabama, it turned to the north until reaching the area of Cleveland, Alabama, and then turned to the east-northeast in the direction of CZL. About 22 nm later, when the airplane was about 10 nm north-northwest of GAD (about 1.7 nm from the accident site), the airplane descended through 2,325 ft msl. Before radar contact was lost, the airplane’s groundspeed had slowed from about 70 to about 40 knots, and its descent rate was about 500 ft per minute.

During a postaccident interview, the family member stated that the pilot sent her a text message from the air, stating that he had found TUP and was on his way back. Another family member thought that the pilot’s plan was to refuel at GAD (before returning to CZL) if the airplane had more than one-half of its fuel left. Later that day, one of the family members became concerned about the pilot, so she called the airport manager at CZL and asked him to check the pilot's hangar to see if he had returned. Because the pilot was not there, the family member asked the airport manager to call the Federal Aviation Administration (FAA). About 1804, the FAA issued an alert notice for the overdue airplane. The airplane was subsequently located about 1030 on September 12. The accident site was about 10 nm from GAD and was approximately in line with the airplane’s track.

According to FAA and pilot records, in addition to his pilot certificate, the pilot held an inspection certificate for the CH750 Cruzer. The pilot did not hold an instrument rating, so he could only operate under visual flight rules. No simulated or actual instrument time was recorded in his logbook.

The pilot had not undergone FAA medical certification examinations and, as a sport pilot, was not required to do so.

The accident airplane was a high-wing, strut-braced, two-seat airplane constructed of conventional metal. The fuel system was configured with two 15-gallon wing tanks and a 2-gallon header tank, which was mounted just behind the engine. The airplane was equipped with a 10-inch Dynon Skyview HDX electronic flight instrumentation system, which included a primary flight display and multifunction display. The airplane was not equipped or certificated for flight in instrument meteorological conditions and could thus only be operated in visual meteorological conditions.

The pilot had obtained a weather briefing during the evening before the accident flight. The weather forecasts (provided by Leidos Flight Service and issued by the National Weather Service) covered the weather conditions that were expected during the flight. No instrument meteorological conditions or restrictions to visibility were forecast near the accident site. Also, graphical forecasts for aviation indicated few to scattered clouds from 3,500 to 4,500 feet msl about the time of the accident.

Low and mid-level troughs were in the area of the accident site and the freezing level above 17,000 ft msl. The closest official weather station to the accident site was the automated weather observing system (AWOS) at Albertville Regional Airport-Thomas J. Brumlik Field (8A0), Albertville, Alabama. According to the 8A0 AWOS, as well as other nearby AWOS and automated surface observing system sites,, the lowest cloud ceiling was about 2,000 ft above ground level (about 3,000 ft msl) with scattered and broken cloud layers through 4,000 ft above ground level (about 5,000 ft msl). Pilot reports indicated cloud ceilings as low as 2,700 feet msl about the time of the accident. Weather satellite information and pilot reports also indicated that the cloud tops were between 4,500 and 6,000 ft msl.

The accident airplane was a high-wing, strut-braced, two-seat airplane constructed of conventional metal. The fuel system was configured with two 15-gallon wing tanks and a 2-gallon header tank, which was mounted just behind the engine. The airplane was equipped with a 10-inch Dynon Skyview HDX electronic flight instrumentation system, which included a primary flight display and multifunction display. The airplane was not equipped or certificated for flight in instrument meteorological conditions and could thus only be operated in visual meteorological conditions.

Examination of the accident site and wreckage revealed that the airplane struck the top of trees in a heavily forested area and impacted the ground in a nose-down attitude of about 45°. There was no wreckage path and no indication of an in-flight fire or explosion. The elevation at the accident site was about 918 ft.

The left wing was bent downward at the wing root, and a corresponding bend was visible on the lift strut for the left wing. The right wing displayed crush and compression damage, the right wing fuel tank was impact damaged and leaking fuel, and the right aileron was separated from its outboard attachment fitting but was still attached to the inboard attachment fitting. The engine was pushed back into the firewall. The throttle control was at idle. The fuel selector was positioned to the left tank, which contained about 2 1/4 gallons of fuel. The right tank contained about 3 gallons of fuel. The header tank also contained fuel, but the amount could not be determined because the fuel could not be recovered due to impact damage.

Examination of the engine revealed that no internal components failed and that all cylinders were intact. Continuity of the drivetrain was established, and the connecting rods, pistons, cam, lifters, pushrods, rocker arms, induction system, and fuel system were all in good condition. The ignition system was unable to be tested because the spark plug wires had been cut and pulled apart during the impact sequence and the electronic coil packs were impact damaged. Visual examination of the ignition system revealed no preimpact anomalies.

The Alabama Department of Forensic Sciences, Huntsville, Alabama, performed an autopsy on the pilot. His cause of death was blunt force injuries. Autopsy findings included an enlarged heart and 50% atherosclerosis of his left anterior descending artery.

Toxicological testing performed at the FAA Forensic Sciences Laboratory found ethanol and Npropanol in the pilot’s blood. Ethanol can be the result of postmortem production, and Npropanol can be produced by microbial processes. Tamsulosin was detected in the pilot’s blood and urine. Tamsulosin is generally a nonimpairing medication that is acceptable for FAA medical certification.