N8360TRobinson Helicopter R22 BETA · 1997

On March 11, 2011, about 1450 Pacific standard time, a Robinson R-22 Beta II helicopter, N8360T, rolled over onto its side after one of its skids contacted the terrain during an instructional flight at North Las Vegas Airport, North Las Vegas, Nevada. The certified flight instructor and his student were not injured, but the helicopter, which was owned by Tamiry Aviation LLC, and operated by 702 Helicopters, sustained substantial damage. The 14 Code of Federal Regulations Part 91 local instructional flight, which was initiated about 50 minutes prior to the accident, was being operated in visual meteorological conditions. No flight plan had been filed.

According to the flight instructor, the primary objective of the instructional flight was to teach his student, who prior to the flight had accumulated less than 2 hours of instructional flight time in a helicopter, how to perform a stationary hover.

While completing the startup and pre-takeoff sequence of checklist items, the instructor noticed, "… a dramatic drop in rpm when the right magneto was checked, but only a four (4) or five (5) percent rpm drop when the left was checked." He therefore checked the right magneto a second time to see if it stayed within the Robinson allowable limitation of no more than seven percent drop within two seconds. During that check the rpm dropped about six or seven percent in two seconds, but then continued to decrease to a total drop of about fifteen percent in about four or five seconds. Although the instructor was "concerned" about the fact that the rpm had continued to drop so far past seven percent, since it technically met the maximum allowable two-second drop limit, he elected to continue the flight.

As the flight continued the instructor noticed that the helicopter required, "… an unusually high power setting to maintain even a 2 or 3 foot hover." He eventually commented to his student that some of the difficulty he was having maintaining a hover might be the result of the helicopter being "very underpowered." About 30 minutes into the flight, because the helicopter did not seem to be performing at the level that the instructor was accustomed to, he decided that he should land and perform another magneto check. During that check the selection of the right magneto produced similar results as during the check that was performed prior to the initial takeoff (a drop of about six or seven percent within two seconds, followed by a continuing total drop of about 15 percent in four or five seconds). After this second magneto check, the instructor ran the engine at a lean fuel setting for about two minutes, hoping to burn off any carbon or lead deposits that may have been affecting the engine's performance. After the completion of these two actions, the instructor lifted the helicopter back into the air in order to detect any change in performance, but he soon determined that, "…nothing had changed in the amount of power required, and it still seemed underpowered, requiring right at about maximum continuous power to hold a 3-foot hover."

The instructor then made the decision to continue the instructional flight, and turned the controls back over to his student. The student then established a hover about three feet above ground level (agl), and was, according to the instructor, hovering fairly well, when the helicopter suddenly began to descend. As the student reacted to the descent, he input right cyclic control, resulting in the right skid coming in contact with the ground with the helicopter tilting to the right. At that time the flight instructor took over the controls and tried to correct the situation by adding left cyclic and up collective, but he was unable to keep the helicopter from rolling over onto its side.

After the accident, the magnetos were bench tested and disassembled with no negative findings, and it was confirmed that the magneto-to-engine timing was correct for both magnetos. It was also noted that both magnetos had their repetitive 500-hour inspection/overhaul less than 45 days prior to the accident. The leads were examined for evidence of frayed shielding or evidence of shorting, and none was found. They themselves showed no evidence of unusual wear, contamination buildup, cracked insulators or shorting. The helicopter's air induction system was inspected, with no negative findings. At the end of the postaccident inspection process, except for some roughness of the paint applied to protect the D-spar bond line on the underside of the main rotor blade tips, a roughness noticed/inspected by the instructor prior to the flight, no component anomaly had been observed that would have contributed to a reduction in performance.

In a postaccident interview, the instructor said that he had received a text message from another certified flight instructor (CFI) the day before the flight. According to this instructor she noticed a performance reduction during that flight that lasted for only two or three minutes of the 30 minute flight. The instructor felt it may have been a magneto or fouled problem. Based upon that text message and the performance degradation that he was detecting during his flight, the instructor said that he had no good reason why he did not discontinue the flight after the second magneto check. He said that he was "uncomfortable" with how much power it took to hover, and how it seemed "very difficult" to maintain the hover height that he normally liked to use during student hover training. He then said "…but for some reason I did not take the controls and return to the south ramp and shut down." He further commented that he may have continued the flight because he supposed that he felt capable of fixing any hover problem the student was having, just like he had done "…probably a thousand times before." Later in a telephone conversation, the pilot admitted that continuing the hovering instructional flight with a low-time student, when it appeared the helicopter may not be performing up to its normal potential, was not a good decision, and that it would have been wise to return to the ramp and terminate the flight after the second magneto check.

It was further determined that the helicopter had flown 6.4 hours since the flight that resulted in the text-message from the other instructor.