N87GXRemos Acft Gmbh Flugzeugbau REMOS GX · 2009

On November 04, 2020, at 1220 mountain standard time, a Remos Aircraft GMBH Fleugzebau, GX, N87GX, was substantially damaged when it was involved in an accident near Glendale, Arizona. The certificated flight instructor and the student pilot were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The flight instructor reported that the purpose of the flight was for the student pilot to practice takeoffs and landings. The flight instructor reported that during a landing, the airplane veered left of the runway centerline, and, in response, he took the controls to prevent a runway excursion. The flight instructor noted that maneuvering the airplane back to the runway centerline was difficult. The airplane subsequently made a grinding noise, and they could feel an unusual vibration. The flight instructor was able to maneuver the airplane to the nearest taxiway, where he shut down the airplane.

A postaccident examination revealed that the aluminum carry-through of the main landing gear failed during landing. A portion of the failed aluminum carry through remained attached to the landing gear and breached the composite structure, entering the cabin floor under the passenger seat. About 12-inches of the carry through structure had separated from the airplane, permitting the horizontal stabilizer and elevator to skid on runway surface, eroding the composite structure.

The failed carry through was sent to the National Transportation Safety Board’s Material Laboratory, and the Senior Material Engineer reported that the carry-through appeared to have failed in overstress. The fracture surfaces all exhibited features consistent with overstress and hardness plus conductivity measurements were consistent with a material that met the minimum strength requirements.

A review of the airframe maintenance logbook indicated that all aircraft safety alerts and airworthiness directives for the airframe had been complied with. On December 17, 2009, the manufacturer issued Service Bulletin SB-002-landing-gear for the accident airplane. The service bulletin required the inspection of the aluminum carry through for the main landing gear immediately if there had been a hard landing in the past, within the next 50 landings, and during scheduled maintenance (100-hr, and Annual Condition Inspection), and after any hard landing. During an interview with the recently hired Light Sport Repairman Maintainer, he reported that he completed the required inspection for cracks, specifically near the weight reduction holes on October 29, 2020.

During the October 2020 100-hr inspection, the maintainer recalled that there were no visible cracks or signatures of deformation to the carry-through. According to the service bulletin, replacement of the carry-through was required as soon as practical but at the latest after detection of cracks, or after 800 total landings, which ever came first. At the time of the maintainer’s inspection, the airplane had accumulated 402 estimated landings and amassed 317.9 total airframe hours. At the time of the accident, the airplane had accumulated 437 estimated landings.